Phone:Fax:OTD-3000FREQUENCY AGILETELEVISION DEMODULATORINSTRUCTION MANUAL025-000053 REV G 6/22/01(209) 586-1022(800) 545-1022(209) 586-1026E-Mail: sal
025-000053 REV GPage 10EXAMPLE:A) Example frequency of 114.00MHz is desired.B) N = (114.00 + 45.75) / .25 = 639, the total switch value required.C) Co
025-000053 REV GPage 11OTD-3000TROUBLESHOOTING ADDENDUMTroubleshooting:1) This unit has a restricted AFC range. This is done to eliminate a problem i
025-000053 REV GPage 123) If the picture quality gets worse in step (2) above by increasing the L.O., the following procedure should beimplemented.Mov
025-000053 REV GPage 2OTD-3000AGILE DEMODULATORThe OTD-3000 is a full feature agile demodulator that is available in four standards - NTSC, PAL B/G, P
025-000053 REV GPage 3RF Input...RF Input Level...
025-000053 REV GPage 41) DEMODULATOR OPERATIONA) Input Channel selection - Remove the front panel plate on the “Input Channel Select” to expose thech
025-000053 REV GPage 5D) After an input channel has been selected, connect an antenna or cable source to the “VHF/UHF”terminal. For optimum video qua
025-000053 REV GPage 6STANDARD CHANNEL CODES FOR OTD-3000
025-000053 REV GPage 7STANDARD CHANNEL CODES FOR OTD-3000 (continued)
025-000053 REV GPage 8H R C CODES FOR OTD-3000 DEMODULATOR
025-000053 REV GPage 9OTD-3000 DEMODULATOR CODESFORNON-STANDARD CHANNELSCOMPUTING SWITCH SETTINGS FOR NON-STANDARD FREQUENCIESThe OTD-3000 can be set
Comentarios a estos manuales