Olson-technology LP-CH-16B Manual de usuario

Phone:Fax:LASER PLUSOPERATING INSTRUCTIONS025-370403 REV X9 12/16/03(209) 586-1022(800) 545-1022(209) 586-1026E-Mail: [email protected]

025-370403 REV X9Page 10 of 11REAR PANELThe RF output connectors are on the rear of the unit. Receiver #1 is on the top. Receiver #3 is on thebottom

025-370403 REV X9Page 11 of 11Laser Plus Module Extraction ToolInsert module puller and slide the notched end underneath the pull tab on the front of

025-370403 REV X9Page 2 of 11TABLE OF CONTENTSSYSTEM OVERVIEW Page 3OPTICAL CONNECTORS & CLEANING Page 4CHASSIS Page 4STATUS MONITORING Page 4&

025-370403 REV X9Page 3 of 11SAFETY WARNINGSLASER RADIATIONThe laser transmitters emit invisible radiation that can cause permanent eyedamage. AVOID

025-370403 REV X9Page 4 of 11OPTICAL CONNECTORS AND CLEANINGThe fiber ends can be damaged by the insertion of contaminated connectors. Some types of

025-370403 REV X9Page 5 of 11There are 3 LED’s on the front of the power supply. The temperature alarm LED is normally green. It changes to red if an

025-370403 REV X9Page 6 of 11INPUT DRIVE vs. CHANNEL LOADINGThe laser RF drive level is the primary determining factor of link distortion and S/N perf

025-370403 REV X9Page 7 of 11The optical power alarm LED is normally green. It turns redon insufficient optical power. 4mW of optical output reads 4.

025-370403 REV X9Page 8 of 11The optical power alarm LED is normally green. It turns redon insufficient optical power. Optical ouput reads as shown b

025-370403 REV X9Page 9 of 11OPTICAL RECEIVER MODULEDESCRIPTIONThe LP-OR is a triple return band receiver in a single module. The receivers have an e